High pressure water sandblasting machine type I

Type I machine: dry high pressure sandblasting machine + water mist sandblasting gun, stainless steel water sandblasting series

■Type II machine: high-pressure water sandblasting machine, high-pressure water sandblasting machine room, rust removal, paint removal and oxide layer cleaning series

■Type III machine: high-pressure water jet sandblasting, high-speed cleaning water sandblasting machine for steel coil and steel plate, rust removal, paint removal and oxide layer cleaning series

■High pressure water sandblasting machine, high pressure water sandblasting machine room

Type I high pressure water blasting machine:

Dry pressure feeding sandblasting machine + environmental protection dust removal water mist sandblasting gun

Features: dry sand in the jar, dry sand in the sand tube, only after the gun is mixed with water mist, does not affect the installation speed of sand abrasives, high efficiency. The disadvantage is that the sand sprayed out is wet, After recycling, it needs to be dried before it can be used in cans, so this machine is suitable for outdoor use of disposable low-cost abrasives (such as river sand, quartz sand, copper ore sand) for sandblasting.

The pressure-feeding mobile sandblasting machine of Dongguan Meijun Sandblasting Equipment adopts the pressure-relieving pneumatic control mode. The characteristics of this machine are:

One person can operate one machine, and can control the startup and shutdown independently, saving manpower;

Pneumatic control, linkage exhaust, pressure relief, make the blasting tank stop the air pressure to 0, the pressure during startup operation does not exceed 6 kg, which is far away from the design pressure of the blasting tank, thus changing the safety hazard of pressurization, and at the same time guaranteeing The sandblasting effect of the high-pressure sandblasting machine is a safe pressure-feeding high-pressure sandblasting machine;

The technology of instantaneous exhaust after shutdown is adopted, which can ensure that the residual air pressure in the tank continues to press the abrasive into the sand tube, causing sand blocking when the machine is turned on again. Sandblasting is carried out at the same time,  effectively control the mixing ratio of high-pressure air and abrasive in the sand tube, reduce the pulse phenomenon, and make the sandblasting very smooth.

Due to the above technical characteristics, the pressure-feeding sandblasting machine of Meijun sandblasting equipment is particularly suitable for long-term sandblasting processing of engineering, and sandblasting of extended pipes (50m/80m/100m), because one person can Operate a machine, turn it on and off at any time, and control it by yourself, which not only saves manpower, but also has the convenience and safety of independent control. It is the preferred sandblasting equipment for sandblasting engineering construction.